Product Help - SVR

Designed specifically to work with the Alarm.com hosted video service, the ADC-SVR122 Stream Video Recorder provides a 24x7 professional local video storage solution. With the Stream Video Recorder, you can connect up to eight Alarm.com video cameras for continuous recording.
  • 1 TB Harddrive
  • Suports Up To 8 Cameras
  • HDMI and USB Ports for Local Control
  • Minimum Bandwidth Requirements:  2 Mbps

Status LED Guide

LED Location

LED Status

Descritpion
Front of SVR

Green | Solid

 Internet connection. Local network and internet connection are active.

Green | Flashing

 Local network connection. Local connection only, no internet.

Red | Flashing

 SVR is booting up or there is no connection to the any network.

Red | Solid

 Cameras not recording or hard drive error.

Red/Green | Flashing

 Factory Reset. Caution: This restores factory-default settings to the device. If already installed, the device may need to be removed from the Alarm.com account and re-added after a factory reset. To perform a factory reset, push the Reset button and release when flashing Green and Red(about 15 seconds).
Back of SVR

Green | Solid

 SVR harddrive is operating normally

Green | Flashing

 Harddrive is full. Normal operation, oldest footage is being deleted.

Red | Solid

 Harddrive error.

Red | Flashing (1 second)

 Harddrive configuration error.

Red | Flashing (2 seconds)

 Harddrive is disconnected

Installation

  • Use an ethernet cable to connect the SVR to your network router.
  • Connect the device’s AC power adapter and plug it into a non-switched outlet.
  • Allow a few minutes for the SVR and router to connect. When the status LED on the front of the SVR is solid green, the connection is complete.
  • From a browser, go to www.alarm.com/addcamera
  • Follow the on-screen instructions to add and set up the SVR.

Click Here to download the installation guide.

Refer to the Alarm.com Knowledge Base for more information.